Roger Beep - older firmware versions
Configuration
The RB is prepared for configuration change by holding the PTT button down for at least
two seconds when power is applied then releasing it.
PTT is again operated and the RB will pulse the transceivers PTT-OUT to the transceiver and a mode is selected by releasing the PTT switch
during the appropriate
pulse. After releasing PTT, wait for two seconds before pressing PTT again.
Table 2: Mode configuration menu - V1.01
| Pulse |
Mode |
Persistent |
Comment |
| 1 |
disable |
YES |
no tone is sent, but PTT is relayed |
| 2 |
T |
YES |
single beep (Morse code T) |
| 3 |
K |
YES |
Morse code K |
| 4 |
V... |
NO |
PTT to activate and deactivate |
| 5 |
continuous |
NO |
PTT to activate and deactivate |
| 6 |
error |
NO |
restarts |
Chips shipped after 3 Jan 2008 are V1.03 or later
Table 2a: Mode configuration menu - V1.03
| Pulse |
Mode |
Persistent |
Comment |
| 1 |
disable |
YES |
no tone is sent, but PTT is relayed |
| 2 |
T |
YES |
single beep (Morse code T) |
| 3 |
K |
YES |
Morse code K |
| 4 |
E |
YES |
single beep (Morse code E) |
| 5 |
V... |
NO |
PTT to activate and deactivate |
| 6 |
continuous |
NO |
PTT to activate and deactivate |
Chips shipped after 21 Apr 2008 are V1.05 or later
Table 2b: Mode configuration menu - V1.05
| Pulse |
Mode |
Persistent |
Comment |
| 1 |
disable |
YES |
no tone is sent, but PTT is relayed |
| 2 |
T |
YES |
single beep (Morse code T) |
| 3 |
K |
YES |
Morse code K |
| 4 |
E |
YES |
single beep (Morse code E) |
| 5 |
V... |
NO |
PTT to activate and deactivate |
| 6 |
continuous |
NO |
PTT to activate and deactivate |
| 7 |
set Morse code speed |
YES |
See below for setting Morse code speed |
Chips shipped after 10 May 2008 are V1.06 or later
Table 2c: Mode configuration menu - V1.06
| Pulse |
Mode |
Persistent |
Comment |
| 1 |
disable |
YES |
no tone is sent, but PTT is relayed |
| 2 |
T |
YES |
single beep (Morse code T) |
| 3 |
K |
YES |
Morse code K |
| 4 |
E |
YES |
single beep (Morse code E) |
| 5 |
V... |
NO |
PTT to activate and deactivate |
| 6 |
continuous |
NO |
PTT to activate and deactivate |
| 7 |
set Morse code speed |
YES |
See below for setting Morse code speed |
| 8 |
set TAPnYAP timeout (min) |
YES |
See below for setting TAPnYAP timeout |
Roger Beep
Changes
| Version |
Date |
Description |
| 1.01 |
|
|
| 1.02 |
|
|
| 1.03 |
|
|
Last update: 09 May 2008 17:06
|